Mounting The Wireless Hub - Raymarine RAY63 Installation And Operation Instruction Manual

2. Ensuring correct orientation of the mounting plate, offer up the plate to the desired location and
mark the location of the screw holes and the center hole on the mounting panel.
To ensure that the handset's connector points down when connected, orientate the mounting
plate so that the lanyard grove is pointing straight up.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting saw.
5. Pull the connector end of the cable through the hole in the mounting surface.
6. Place the Mounting plate gasket over the end of the connector.
7. With the recessed side facing away from the mounting panel, place the Mounting plate over
the end of the connector.
8. Place the lanyard end of the Splash-proof dust cap over the connector, ensuring the lanyard sits
in the recess in the Mounting plate.
9. Place the Mounting plate nut over the connector and tighten clockwise using a 13/16 in. (21 mm)
socket wrench, being careful not to damage the plastic nut by overtightening.
10. Secure the Mounting plate to the mounting surface using the supplied screws.
11. Attach the Handset / Fistmic connector to the cable connector and rotate the locking collar
clockwise to secure.
12. Connect the opposite end of the cable to the required connector either on the Base station or to
another pass-through panel mounting plate connector.
Note:
Drill bit, tap size and tightening torque is dependent on the thickness and type of material the unit
is to be mounted on.

Mounting the wireless hub

Before mounting, ensure that:
• your selected location meets the location requirements found in this document.
• you pay particular attention to the wireless location requirements.
• sufficient space is available above or to one side of the hub for the antenna.
• the product operates correctly at the desired location before mounting.
68