Note:
Drill bit, tap size and tightening torque is dependent on the thickness and type of material the unit
is to be mounted on.
Mounting the wireless hub
Before mounting, ensure that:
• your selected location meets the location requirements found in this document.
• you pay particular attention to the wireless location requirements.
• sufficient space is available above or to one side of the hub for the antenna.
• the product operates correctly at the desired location before mounting.
1. Using the supplied mounting template, mark the location of the fixing holes on the mounting
surface.
2. Drill holes for the mounting fixings using a drill with a suitable sized drill bit.
3. Screw the fixings approximately half way into the holes in the mounting surface.
4. Place the Wireless hub over the fixing screws and push down to lock into positions
5. Fully tighten the screws.
6. Connect the antenna to the top of the hub.
Installation
41