Raymarine RAY63 Installation And Operation Instruction Manual page 62

1. Check the selected location for the unit. A clear, flat area with suitable clearance behind the
panel is required.
2. Fix the supplied mounting template to the selected location, using masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated on the template), make a hole in each corner
of the cut-out area.
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. Ensure that the unit fits into the removed area and then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to accept the fixings.
7. Remove the backings from the supplied gasket.
8. Place the gasket in position on the back of the unit and press firmly onto the flange.
9. Connect the power, and other cables to the unit.
10. Slide the unit into place and secure using the fixings provided.
11. Attach the front bezel.
Note:
The supplied gasket provides a seal between the unit and a suitably flat and stiff mounting surface
or binnacle. The gasket should always be used. It may also be necessary to use a marine-grade
sealant if the mounting surface or binnacle is not entirely flat and stiff or has a rough surface finish.
Attaching the front bezel
After installation of the Radio the front bezel can be attached following the steps below.
The following procedure assumes that the unit has already been mounted in position.
62