Selecting (Gnss) Gps Information To Display; Setting Time Format And Offset; Station Priority (Ray63 And Ray73 Only) - Raymarine RAY63 Installation And Operation Instruction Manual

2. Use the Rotary knob or the Channel Up and Channel Down buttons on a Raymic handset to cycle
through the available numbers and press OK to confirm each number and move to the next digit.
3. When the relevant information has been entered select OK to confirm the details.

Selecting (GNSS) GPS information to display

You can change the GNSS (GPS) data that is displayed on the Homescreen.
From the GPS set-up menu: Menu > Set-up > GPS set-up.
1. Select Homescreen display.
Selecting Homescreen display will switch between Location & time and Location & COG/SOG.
The Homescreen display option is also available from the Display set-up menu: Set-up > Display
set-up > Homescreen display.

Setting time format and offset

You can change the Format and Offset that is applied to the time displayed onscreen.
From the Units menu: Menu > Set-up > Units.
1. Select Time format.
Selecting Time format will switch between 12 hour and 24 hour format.
2. Select Time offset.
3. Adjust the offset to the desired value using the Rotary knob or the Channel Up and Channel
Down buttons on a Raymic handset.
4. Select OK to confirm the selection.

9.20 Station priority (Ray63 and Ray73 only)

The Ray63 and Ray73 can have a Local Fistmic, connected to the front connector, and a Raymic
(remote) handset, connected to the rear connector.
The following rules apply to station priority:
• The Local station always takes priority over the Remote station.
• Unless a Distress call is in progress, any button press on the Local station will take control from
the Remote station.
• If the Remote station is inactive for 3 seconds, the Local station can take control and complete
an incomplete Distress call.
• The Local station can interrupt the Remote stations's voice broadcasts by pressing the PTT button.
• The Local station will retain control for 3 seconds after the last button press.
• The information on the station which has control is repeated on the other station's display.
114