Supermicro X10SRH-CF/CLN4F User Manual page 128

X10SRH-CF/CLN4F User's Manual
3. Enable BIOS Resilience mode in remote IPMI and confirm.
•
To enable, type the following command in the command prompt:
ipmi raw 30 70 C2 D5 00 00
•
To confirm, type the following command in the command prompt:
impi raw 30 70 C3 D5
4. Mount the USB flash drive with Super.ROM to remote Virtual Media Device 1.
This must de done in the IPMI Shell mode.
•
To enter the IPMI Shell mode, type: shell
•
To see the list of drives, type: vmwa dev1list
•
To mount the drive, type: vmwa dev1drv 2.
In this example, the USB flash drive is drive #2 (drv 2). Drive numbers may
vary in each system.
•
To confirm if the drive is mounted, type: vmwa status
D-8