To disable or enable Bluetooth:
• Connect with the VictronConnect app to the solar charger. Note that if Bluetooth has been disabled, a connection via its built-in
Bluetooth is not possible anymore. In that case use the
VRM to connect to the solar charger.
• Select the solar charger from the VictronConnect list.
• Navigate to the solar charger settings page by clicking the cog symbol
• Navigate to the product info page by clicking on the 3 dot symbol in the top right hand corner.
• Enable or disable the Bluetooth setting.
• In case of disabling Bluetooth, tick the checkbox confirming you understand that once Bluetooth has been disabled, a Bluetooth
connection with the solar charger is not possible anymore.
5.5. VE.Smart Networking
VE.Smart Networking allows a variety of products connected to the same network to share data via Bluetooth and is specially
designed for smaller systems that do not have a GX device installed.
When this product is part of a VE.Smart Network, it can receive data or communicate with the following devices:
Page 34
MPPT solar charger manual
VE.Direct to USB
interface, the
in the top right hand corner.
Disabling or enabling Bluetooth
VE.Direct Bluetooth Smart dongle
Configuration and settings
or