Specifications - Strong SRT 32HC2003 User Manual

Problem
Normal picture, no sound
Playback of video is
causing picture freeze/
macro blocks or similar
distortion, especially on
HD content.
The remote control does
not work
The TV switches off after a
certain time
NOTE:

8.0 SPECIFICATIONS

Audio
Audio Output:
Video
QPSK,16QAM,64QAM
www.strong.tv
1. Press the volume up button to increase the volume level.
2. Audio is muted, press ! to restore the sound.
3. If external devices are used to loop the sound through,
make sure to select correct sources and correct sound
mode, for details also check advices in User Manuals
from connected devices
4. Maybe a channel w/o audio is tuned to (demo) or the
programme is not transmitting audio signals or there is
some other transmission interference/failure.
Read/write speed of your USB device could be too low. Make
sure to use a USB storage device with sufficient speed and space.
Pen drives (USB sticks) may not support sufficient speed.
1. hange the batteries. If you're using rechargable ones
take care to use such with low self-discharge
2. The batteries are not installed correctly or the types
have been mixed
3. IR Sensor is blocked or maybe interfered from bright
light
Switch ON the TV and check settings for automatic STBY
function, by default the TV switches OFF after 4 hours to fulfil
European low power regulations and help you to save energy.
If the problem persists after these solutions, please contact your local
support centre or send a support mail via our website www.strong.tv.
10 W + 10 W
DVB-T: Reception range: VHF (50MHz ~ 230MHz),
UHF (474MHz ~ 862MHz)
Input impedance: 75Ω
Channel Bandwidth: 7MHz/8MHz
Modulation: DVB-T: COFDM 2K/8K
DVB-S/S2: QPSK ,8PSK
DVB-T2: QPSK,16QAM,64QAM,256QAM
DVB-C: 16QAM, 32QAM, 64QAM, 128QAM, 256QAM
Video System: MPEG-2 MP@ML, MPEG-2 MP@HL, H.2
Main/Main-
10 profile, @L4.1, Support 8-bit/10-bit color depth,
1920x1080@60fps
Possible cause and solution
19