Table of Contents
Advertisement
Chapter 7 Wireless
7.7 The WDS Screen
An AP using the Wireless Distribution System (WDS) can function as a wireless network bridge
allowing you to wirelessly connect two wired network segments. The WDS screen allows you to
configure the Device to connect to two or more APs wirelessly when WDS is enabled.
Use this screen to set up your WDS (Wireless Distribution System) links between the Device and
other wireless APs. You need to know the MAC address of the peer device. Once the security
settings of peer sides match one another, the connection between devices is made.
Note: WDS security is independent of the security settings between the Device and any
wireless clients.
Note: At the time of writing, WDS is compatible with other ZyXEL APs only. Not all models
support WDS links. Check your other AP's documentation.
Click Network Setting > Wireless > WDS. The following screen displays.
Figure 41 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
Table 27 Network Setting > Wireless > WDS
LABEL
Wireless Bridge Setup
AP Mode
Bridge Restrict
118
DESCRIPTION
Select the operating mode for your Device.
•
Access Point - The Device functions as a bridge and access point simultaneously.
•
Wireless Bridge - The Device acts as a wireless network bridge and establishes
wireless links with other APs. In this mode, clients cannot connect to the Device
wirelessly.
This field is available only when you set operating mode to Access Point.
Select Enabled to turn on WDS and enter the peer device's MAC address manually in the
table below. Select Disable to turn off WDS.
VMG1312-B10B / VMG1312-B30B Series User's Guide
Advertisement
Table of Contents
