Supplies And User Maintenance; Td Cartridge Replacement - Sharp AL-1041 Operation Manual

5

SUPPLIES AND USER MAINTENANCE

This chapter describes how to replace the TD cartridge and the drum cartridge and how to
check the total number of copies.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required ( ) indicator will light up when toner is needed. For
more information on purchasing the TD cartridge, see OPTION AND SUPPLY PART NUMBERS
AND STORAGE on page 39. If copying is continued while the
gradually become lighter until the copier stops and the indicator begins blinking. Replace the
old TD cartridge by following the procedure given below.
After the copier stops, it may be possible to make a few more copies by
taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling
it. If copying is not possible after this operation, replace the TD cartridge.
During long copy run of a dark original, the ready (
the indicator light up, and the copier stop, even though toner is left. The
copier will feed toner up to 2 minutes and then the ready (
light up. Press the print (
Ensure that the bypass tray is open and then open the side cover while pressing the
1
side cover open button.
Then, push gently on both sides of the front cover to open the cover.
Gently pull the TD cartridge out while pressing the lock release button. Dispose of the
2
old TD cartridge in accordance with local regulations.
) key to restart copying.
Lock release button
indicator is lit, copies will
) indicator may blink,
) indicator will
5
27