Transfer Charger; When Copier Is Not In Use - Sharp AL-1041 Operation Manual

USER MAINTENANCE

Transfer charger

If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the charger
using the following procedure.
Turn the power switch off.
1
Ensure that the bypass tray is open and then open the side cover while pressing the
2
side cover open button.
Take the charger cleaner out by holding the tab.
3
Set the charger cleaner onto the transfer charger and gently slide the cleaner back
and forth two or three times.
5
Return the charger cleaner to its original position. Close the side cover by pressing
4
the round projections near the side cover open button.
Turn the power switch on.
5

When copier is not in use

To prevent entry of dust and foreign matter, store the copier as follows.
Remove the power cord and secure the copier using tape (two locations).
1
30
Slide the charger cleaner from one end to the other end along the groove of
the transfer charger. If the cleaner is stopped on the way, smudges on copies
may occur.