Loading A Roll Of Labels - Seiko SLP100 User Manual

Loading a Roll of Labels

Follow the instructions below to load a roll of standard
address labels.
Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of
labels.
Note...
the label backing as illustrated on page 2-3.
2 If needed, cut between the labels to create a "leader."
Prepared end
If the end of the roll is not prepared as shown above, cut
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and that the
printer is turned on.
The green status light should be flashing.
2 Lift the base of the clear plastic label cover and rotate it
open.
User Guide
Check to be sure there is a black sensor mark on
Roll
Spindle
Getting Started
Chapter 2
Waste Roll
Cut here
Label
Cover
2-7