Setting up the Printer
If the printer is not recognized using the installation wizard, you will need to set up your printer manually.
To do so, follow these steps:
Prepare the Roll of Labels
1. Open the Smart Label printer software.
2. Under the Label pull-down menu, select Printer Set-up.
3. Select Add a printer.
4. Select how your printer is connected and click Done.
Loading a Roll of Labels
Prepare the Roll of Labels
1. Remove the sticker from the beginning of the roll of labels.
Note: Make sure there is a black mark on the label backing as shown in
"A WORD ABOUT LABELS".
2. If necessary, cut between the labels to create a "leader".
If the end of the roll is not prepared as shown above, cut between the labels leaving as much backing as
possible on the end of the roll to act as a leader.
Roll
Prepared end
Roll
Waste
Cut here
12