Connecting The Slp To An Ibm-Compatible Pc - Seiko SLP100 User Manual

Connecting the SLP to an IBM-compatible PC

Use the USB or serial cable provided with the SLP 100/200/
240 to connect the SLP to your computer.
Follow these steps:
1 Make sure that the SLP is turned off. If the status light is
on, hold the power button until it turns off.
2 Connect either the USB or serial cable.
USB cable. Connect the cable to the SLP and the USB port
on your computer. If all USB ports are in use, you may
need to purchase a USB hub.
Serial cable. Plug the telephone-style connector into the
jack on the rear panel of the SLP. Plug the other end of
the cable into a serial port on your computer.
Note...
COM2, COM3, etc. If your COM ports are all in use,
purchase either another serial port or an "A-B" switch
box to connect the SLP and another device to the same
port.
USB port
DO NOT use
both cables
2-6
CAUTION: Connecting or disconnecting the interface
cable while the printer is turned on may damage the
printer.
Serial ports are also called COM ports — COM1,
Serial port
Smart Label Printer Models 100, 200 and 240
Chapter 2
Serial Cable
OR
USB cable
Getting Started