Installing The Smart Label Software - Seiko SLP100 User Manual

Installing the Smart Label Software

1 Start Windows.
2 Insert the Smart Label CD-ROM or installation disk 1 into
the appropriate drive. When using the CD-ROM, the
installation wizard starts automatically on most systems. If
the introductory screen doesn't appear after a few sec-
onds, continue with the following steps.
3 Click the Start button then point to Settings and choose
Control Panel. The Control Panel window appears.
4 Double-click Add/Remove Programs. The Add/Remove
Programs Properties dialog box appears.
5 Click the Install button. A dialog box appears asking you
to insert the floppy disk.
6 Click the Next button. The drive and SETUP.EXE file are
automatically selected and shown in the command line
box.
7 Click the Finish button. Follow the directions on the
screen to complete the installation of the program.
The installation wizard will assist you in configuring how
the SLP is connected. The SLP may be connected directly to
your computer or to a remote network computer.
Serial (COM). The SLP is connected to a serial port on
n
your computer.
USB. The SLP is connected to a USB port on your com-
n
puter.
Parallel (LPT). The SLP is connected to an parallel port
n
on your computer using the serial cable and an optional
serial-to-parallel adapter.
Network. The SLP is connected to another computer on
n
your network.
2-10
Chapter 2
Smart Label Printer Models 100, 200 and 240
Getting Started