Loading A Roll Of Labels - Seiko SLP120 User Manual

Loading a Roll of Labels

Follow the instructions below to load a roll of standard
address labels. Instructions on loading other label types
appear in Chapter 3.
Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of
labels.
Note... Check to be sure there is a black sensor mark on
the label backing as illustrated on page 2-3.
2 If needed, cut between the labels to create a "leader."
If the end of the roll is not prepared as shown above, cut
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and the printer is
turned on.
The green status light should be flashing.
2 Lift the base of the clear plastic label cover and rotate it
open.
User Guide
Roll Waste
Prepared end
Spindle
Getting Started
Chapter 2
Roll
Cut here
Label
cover
2-7