Removing Stuck Labels - Seiko SLP100 User Manual

Changing Labels and Printer Care
Chapter 3

Removing Stuck Labels

If a label becomes stuck in your SLP, remove it as follows:
1 With a pair of scissors, cut the label stock between the
label roll and the label slot at the back of the printer.
2 Swivel the label cover open and remove the print engine
cover by pulling forward on the tabs at the top of the
cover.
3 Release the pressure on the label stock by moving the
platen release lever forward.
4 Remove the stuck label.
5 If the label — or pieces of the label — stick to the platen,
use a small amount of isopropyl rubbing alcohol on a
cotton swab to dissolve the adhesive on the back of the
label.
6 Once you have removed any remaining pieces of label,
return the platen release lever to the locked position.
7 Insert the tabs on the lower edge of the print engine
cover into the slots on the SLP and push the top edge for-
ward until the cover snaps into place.
User Guide
CAUTION: DO NOT touch the print engine. It may be
hot.
3-5