Panasonic KX-TG6500C Operating Instructions Manual page 99

TG6500C_Usefulinfo.fm Page 99 Thursday, September 30, 2004 4:58 PM
Problem
An incoming message recorded
for a line is not played after
pressing [MESSAGE].
Memo messages are not
played after pressing
[MESSAGE].
General
Problem
The handset/base unit does not
work.
"Recharge battery" is
displayed, " " flashes,
3
or the handset beeps
intermittently.
"Charge for 6 HRS" and
" " are displayed and the
4
handset does not work.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash, or "Charge
for 6 HRS" and "
4
displayed.
The CHARGE indicator does
not go out after the battery has
been charged.
• Select the line for that message by pressing
[LINE SELECT], then press [MESSAGE]
(p. 74).
• You may have pressed [LINE SELECT] before
pressing [MESSAGE]
again without pressing [LINE SELECT] (p. 74).
• Check the settings (p. 12–17).
• Check whether the dialing mode setting is
correct (p. 23).
• Fully charge the battery (p. 16).
• Clean the charge contacts and charge again
(p. 17).
• Check battery installation (p. 16).
• Unplug the base unit's AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 92, steps 5
and 6).
• Re-install the battery (p. 16) and fully charge it.
• Fully charge the battery (p. 16, 17).
• The battery has been discharged. Fully charge
the battery (p. 16, 17).
• Clean the charge contacts and charge again
(p. 17).
" • The battery may need to be replaced. If you
3
install a new battery, fully charge it (p. 16, 17).
" are
• This is normal.
Troubleshooting
Cause & Remedy
.
Press [MESSAGE]
Cause & Remedy
99