Table of Contents
Advertisement
TG6500C_Usefulinfo.fm Page 96 Thursday, September 30, 2004 4:58 PM
Troubleshooting
Problem
You cannot program any
function items.
While programming or
searching, the handset or base
unit starts to ring and the
program/search stops.
You cannot make an intercom/
outside call.
You cannot redial.
You cannot make long
distance calls.
96
Cause & Remedy
• Programming is not possible while the
handset or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to messages or
the Answering System is handling a call, you
cannot program. Try again later.
• A call is coming in. To answer the call, press
[
], [s], or the called line soft key (
C
or (
) on the handset, or press
LINE2
[SP-PHONE] or the called line button on the
base unit. Start again from the beginning after
hanging up.
• If more than 1 other user is using the handset
and/or base unit, you may not be able to make
a call. Try again later.
• Your handset is in remote operation mode
(p. 75). Exit by pressing [OFF].
• The handset you called is too far from the
base unit.
• If the last number dialed was more than 48
digits long, the number will not be redialed
correctly.
• The [REDIAL/PAUSE] button functions as
either redial or pause. It will redial the last
number dialed if pressed before dialing any
digits (p. 36, 40). If another number has been
dialed first, it will operate as a pause button
(p. 66).
• Please make sure that you have long distance
service.
)
LINE1
Advertisement
Table of Contents
