Table of Contents
Advertisement
TG6500C_Preparation.fm Page 22 Thursday, September 30, 2004 4:54 PM
Programmable Settings
Date and Time
We recommend you set the date and time so that the unit will announce the day
and time each message was recorded when you play back messages.
1
Press [MENU].
2
Scroll to "Date and time" by pressing [d]
or [B], then press the soft key (
3
(1) Enter 2 digits each for the month, day and
year. (e.g. To set May 15, 2004, enter
"05 15 04".)
(2) Enter 4 digits for the time (hour and
minute). (e.g. To set 9:30, enter "0930".)
• If you enter a wrong number, press the soft key
(
) or (
f
move the cursor to the incorrect number. Enter
the correct number.
4
Select "AM" or "PM" by pressing [*].
5
Press the soft key (
• The date and time are set and "
• If the handset beeps 3 times, the date and time were not set correctly. Start
again from step 3.
6
Press [OFF].
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter "0100", and select "PM" in step 4.
• When the display language is set to French, you can use military time (see
page 22 of the French Operating Instructions).
The date and time may be incorrect after a power failure. When "
the base unit display, set the date and time again.
To confirm the date and time, repeat steps 1 and 2.
• The current date and time are displayed. When finished, press [OFF].
22
Handset
SELECT
), or press [B] or [d] to
g
).
SAVE
" disappears from the base unit display.
E
Date and time
).
Date:|
1 2.31.2004
Time:12:00 AM
0-9=Date&Time
@=AM/PM
f
g
Date:|
0 5.15.2004
Time:09:30 AM
0-9=Date&Time
@=AM/PM
f
g
" flashes on
E
SAVE
SAVE
)
Advertisement
Table of Contents
