Fox-18 Reassembly After Shipping Procedure From A 2.4 Meters Short Package - Aeros FOX-18 Owner's Service Manual

Figure 63 Figure 64
14.20 Put the 2.4 meters transportation bag on the glider (fig. 65). Now your glider is ready for
transportation (fig. 66).
Figure 65 Figure 66
Fox-18 reassembling procedure from a 2.4 meters short package is reverse to its breakdown procedure.
Please read written above manual and be sure you thoroughly understand it before reassembling your
glider from a 2.4 meters short package.
15. Fox-18 REASSEMBLING AFTER SHIPPING PROCEDURE FROM A 2.4 METERS
SHORT PACKAGE
Please read and be sure you thoroughly understand this manual before reassembling you glider from a
short package. Also re-read section "Fox-18 breakdown for shipping procedure in a 2.4 meters short
package" and refer to photos from this section, if necessary, during reassembling procedure.
15.1 Same as for breakdown procedure, you will need an unobstructed area 2.4 m by 9 m (8x30 ft). Make
sure the surface is clean. If it is abrasive, you should either cover it with protective tarp or be extremely
careful not to scrape your sail.
Remove the 2.4 meters short transportation bag from the glider. Unfold the 6 meters bag with the sail in it
and take the frame off the glider bag (fig. 67).
25