Fox Reassembling After Shipping Procedure From A 2 Meters Short Package; (Fox-B And Fox-Bm Models Only) - Aeros Fox-16 Owner's Service Manual

Figure 44 Figure 45
Fox reassembling procedure from a 2 meters short package is reverse to its breakdown procedure.
Please read written above manual and be sure you thoroughly understand it before reassembling your
glider from a 2 meters short package.
14. FOX REASSEMBLING AFTER SHIPPING PROCEDURE FROM A 2 METERS
SHORT PACKAGE (Fox-B and Fox-BM models only)
Please read and be sure you thoroughly understand this manual before reassembling you glider from a
short package. Also re-read section "Fox breakdown for shipping procedure in a 2 meters short package
(Fox-B and Fox BM models only)" and refer to photos from this section, if necessary, during reassembling
procedure.
1. Same as for breakdown procedure, you will need an unobstructed area 2 m by 9 m (6x30 ft). Make
sure the surface is clean. If it is abrasive, you should either cover it with protective tarp or be extremely
careful not to scrape your sail.
Remove the 2 meters short transportation bag from the glider. Unfold the 6 meters bag with the sail in it
and take the frame off the glider bag (fig. 46).
Figure 46 Figure 47
2. Check completeness of the frame parts and make sure they have no damage after transportation.
Rotate the control frame around its apex backwards so, that the control frame lower fittings are directed
aft (fig. 47).
Connect the rear keel tube with the front keel tube. Align both tubes and than slide the rear keel tube
forward, rotating as necessary, until the button spring in the rear keel tube engages securely into the hole
in the front keel tube.
3. Identify the leading edges as to front, middle and rear. Identify them as left and right, checking the
"right" / "left" markings in order to make sure you are mounting leading edges correct.
Connect the middle leading edge with the front leading edge. Align both tubes and slide the middle
21