Aeros FOX-18 Owner's Service Manual page 16

11.2 Remove the keel tube extension from the keel tube and support the glider under the keel tube with it.
11.4 Remove all top surface battens including the tip battens, except for the battens # 1.
11.5 Install the wingtip protection bags.
11.6 Install the keel tube extension back in the keel tube and lower the glider on the keel tube with the
wingtip protection bags on.
11.10 Fold the wings all the way towards the keel pulling the sail over the top of the leading edges. At
each wingtip, remove the tip cover bag. Install the protective pads on the keel tube over the rear wires
junction (fig. 36) and on the rear end of the keel tube (fig. 37). Install the protective bag on the top of the
kingpost (fig. 38).
11.3 Pull out the outboard sprogs, swing them
towards the leading edge and fix with Velcro (fig.
33).
Figure 33
11.7 Unhook the shackle and de-tension the
crossbar sweep wires. Let the wings fold in slightly.
The kingpost will automatically go down (fig. 34).
11.8 Install the protective pad on the top of the keel
tube above the control frame apex and fix the flaps
of the protective pad around uprights (fig. 35).
11.9 Detach the bottom front wires at the nose plate.
Figure 34
Figure 35
16
Figure 36