Trike Assembly After Shipping Procedure - Aeros -2 Maintenance Manual

Adjust one wingtip at a time and test fly after each adjustment.

15. TRIKE ASSEMBLY AFTER SHIPPING PROCEDURE

The trike is shipped in a wooden box. Having used the specific techniques described in this
manual you will perform the assembly procedure of your trike without any difficulties.
1. Remove the wooden bar installed near the universal junction of the trike.
ATTENTION! If your trike is equipped with the hydraulic brake system, before removing the
box sides it is necessary to disconnect the axels in the box corners and temporarily tie them up to
the engine to avoid the brake system lines damage.
2. Remove all box sides.
3. Take the 8 mm diameter heart bolt with the handle out of the plastic which is located next to
the universal junction and insert the bolt in the hole of the universal junction.
4. Cut off the scotch tape and take out propeller blades, the windshield and other parts.
5. Cut away packaging material and take out the wheel cowls.
6. Carefully lift the pylon up. Take out the propeller hub and other parts from the rear seat.
7. Connect the strap with the braking load more than 300 kg to the heart bolt and lift up the trike
with the box base using a winch.
8. Lay wooden boards under the box base and lower on them the box base with the trike.
9. Remove brackets fixing bolts at the box base.
10. Lift up both the back sides of the trike with a winch and the front side of the trike by hands
and remove the box base from under the trike.
11. Dismount all parts from the box base and unpack them.
25