Table of Contents
Advertisement
14.3 Unbolt bottom and upper side wires from the crossbar and feed the upper side wire through the hole
and out of the sail (fig. 54).
Figure 54
Figure 55
14.4 Unbolt the upper front wire from the nose plate and feed it through the hole and out of the sail (fig.
55).
14.5 Remove the keel pocket mounting screw from the keel pocket webbing at the rear part of the keel
tube. Detach the rear bottom cables from the keel tube.
14.6 Unbolt the crossbar from the leading edge tube. Remove the crossbar ends from the sail.
14.7 Remove the clevis pin from the top of the kingpost and detach the top rear wire from the kingpost.
Install the clevis pin back on the kingpost.
14.8 Unscrew the carabiner and detach the shackle of the sweep wires from the rubber cord.
14.9 Feed the webbing handle with the top rear wire out of the sail opening. Slide the crossbar central
joint along the keel tube towards the nose plate.
14.10 Detach washout bridles from the sail.
14.11 Slide the frame forward and out of the sail through the nose hole of the sail. If you encounter
resistance, stop and find out what is hanging up.
14.12 Fold the sail along its leading edge carefully. Put the sail in the glider bag, making sure the wider
part of the sail goes into the wider part of the glider bag and zip the glider bag up (fig. 56, 57).
Figure 56
Figure 57
14.13 Remove battens from the batten bag. Disconnect battens #1 and #2 and put all battens back in to
the batten bag.
23
Advertisement
Table of Contents
