Table of Contents
Advertisement
Using the imagePRESS Server
This chapter describes how to use the imagePRESS Server.
Starting, shutting down, rebooting, and restarting the imagePRESS
Server
Always use the following procedures to start, shut down, reboot, or restart the imagePRESS Server.
IMPORTANT:
Always verify that the imagePRESS Server is not in use before you power off or restart it. Make sure that the system is not
processing or printing a job. Before you take the imagePRESS Server off the network, always obtain permission from the
network administrator.
To start the imagePRESS Server
1. Press the power switch to set ON (|).
2. Power on the printer using the main power switch.
The imagePRESS Server will automatically turns on as the printer warms up.
If it has been enabled in Setup, the imagePRESS Server Start page will also print automatically when the imagePRESS Server
is ready for use.
NOTE:
If the imagePRESS Server does not start up within 10 minutes, see the Startup section of "Table 1: Causes and solutions when
printer does not print"
on"If the printer does not print" on page 56
To shut down the imagePRESS Server
1. Make sure that the imagePRESS Server is not receiving, processing, or printing any jobs.
2. Make sure that the printer is not in use.
3. Power off the printer using the main power switch on the front.
The imagePRESS Server will automatically start the shutdown process. Wait for the printer and the imagePRESS Server to
power off completely.
4. Move the imagePRESS Server power switch to the OFF (O) position.
To restart the imagePRESS Server
1. Make sure that the imagePRESS Server is not receiving, processing, or printing jobs.
2. From the printer control panel, press Main Menu button. If the Fiery icon does not appear on the copier touch panel, press
Show All.
3. From the printer touch panel, select Fiery > Tools > Restart Server.
Starting the imagePRESS Server
7
2. USING THE IMAGEPRESS SERVER
Advertisement
Table of Contents
Troubleshooting
