Troubleshooting - Walgreens Well WGNBPA-945 Manual

TROUBLESHOOTING

If any abnormality arises during use, please check the following points.
SYMPTOMS
Unit does not turn
on when the START/
STOP button is
pushed.
EE measurement error
symbol shown on
display or the blood
pressure value is
displayed excessively
low (or high).
E1 error symbol shown
on display
E2 error symbol shown
on display
E3 error symbol shown
on display
EP error symbol shown
on display
Note: If the unit still does not work, contact HoMedics Consumer Relations.
Under no circumstance should you disassemble or attempt to repair
the unit by yourself. Contact information for HoMedics Consumer
Relations Department can be found on the warranty page.
POSSIBLE
CAUSES
Batteries have
run down.
Battery polarities
have been positioned
incorrectly.
Cuff has been placed
incorrectly.
Did you talk or move
during measurement?
Shaking of the arm with
the cuff on.
Air circuit abnormality.
Cuff tube may not be
plugged into monitor
correctly.
Inflation pressure
exceeding 300 mmHg.
Error determining
measurement data.
System error.
29
CORRECTION
Replace them with
four new "AAA"
alkaline batteries.
Re-insert the batteries in
the correct positions.
Wrap the cuff properly so
that it is positioned
correctly. Measure again.
Keep arm steady during
measurement. Measure
again.
Check cuff connection.
Measure again.
Switch the unit off, then
measure again.
Measure again.
Turn off monitor and
measure again. If 'EP'
error still appears on the
display, please call a
Consumer Relations rep-
resentative.