Troubleshooting; Specifications - Walgreens WGNBPW-920 Manual

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn on when Batteries have
the START/STOP run down.
button is pushed.
Battery polarities have been
positioned incorrectly.
EE measurement error Cuff has been placed incor-
symbol shown on display rectly.
or the blood pressure value
is displayed excessively low
Did you talk or
(or high).
move during
measurement?
Shaking of the wrist with the
cuff on.
E1 error symbol shown on Air circuit
display abnormality.
E2 error symbol shown on Inflation pressure exceeding
display 300 mmHg.
E3 error symbol shown on Error determining measure-
display ment data.
EP error symbol shown on System error.
display
Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance
should you disassemble or attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on the warranty page.
CORRECTION
Replace them
with two new "AAA" alkaline
batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff properly so that it
is positioned correctly. Measure
again.
Keep wrist steady during
measurement. Measure again.
Measure again.
Switch the unit off, then measure
again.
Measure again.
Measure again.
33

SPECIFICATIONS

Power Source: Two 1.5V DC "AAA" Alkaline batteries
Measurement
Oscillometric
Method:
Measurement Pressure: 40~280 millimeters Mercury (mmHg)
Range: Pulse: 40~199 beats/minute
Pressure: ±3 mmHg
Accuracy:
Pulse: ±5% of reading
Pressure Sensor: Semi-conductor
Inflation: Pump driven
Deflation: Automatic Pressure release valve
Memory Capacity: 100 memories for each User (200 total)
Auto-shut-off: 1 minute after last button operation
Operation Temperature: 41°F~104°F (5°C~40°C)
Environment: Humidity: 15% ~ 93% RH
Storage/
Temperature: -13°F~158°F (-25°C~70°C)
Transportation
Humidity: Less than 93% RH
Environment:
34