Oki NeonColor Pro6410 User Manual page 57

ITEM
Flash Initialize
Memory
Setup
System Near Life
setup Status
Near Life
LED
Time Setup Date Format
Time Zone
Daylight
Saving
Time Setting
Change New
Password Password
Verify
password
SETTINGS EXPLANATION
Execute Initializes Resident FLASH.
When the Enter button is pressed, the following
confirmation message appears.
Are You Sure?
If No is selected, the previous menu display resumes.
If Yes is selected, the following confirmation message
displays.
Execute Now?
If No is selected, the previous menu display resumes. At
this time, the request to execute FLASH initialization is
put into the memory and initialization will be executed at
power cycle.
If Yes is selected, shutdown takes place, and FLASH is
initialized at power Off/On cycle.
Enable/Disable Set LCD panel control at the time of near-life warning for
Print Cartridge, fuser and belt.
Enable: Display a near-life warning.
Disable: Do not display a near-life warning.
Enable/Disable Controls the settings of the Attention LED when near
end of life warning of Print Cartridge, fuser, or belt occurs.
Attention LED is lit when enabled, not lit if disabled.
(Displays LCD message.)
The temporary recovery by opening and closing of the
cover in Life error is not included.
mm/dd/yyyy Set desired date format.
dd/mm/yyyy
yyyy/mm/dd
-13:00 Enter the time zone for your country in relation to GMT.
~ Set in quarter units within the range.
0:00 Use the Menu up/down buttons to increment/decrement
and press the Enter button to set and proceed to the next
~
digit.
+13:00
On Enable/disable daylight saving setting.
Off
01/01/2000 Set current date and time.
00:00
Display format follows the settings selected in Date
~ Format.
01/01/2009
00:00
~
31/12/2091
23:59
xxxxxxxxxxxxxx Sets a new password to enter Admin Setup menu
From 6 to 12 alpha/numeric digits can be entered.
xxxxxxxxxxxxxx Forces the User to input the new password to enter Admin
Setup.
From 6 to 12 alpha/numeric digits can be entered.
Menu functions > 57
Yes/No
Yes/No