Fujitsu fi-475PR User Manual page 4

FCC Declaration:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTICE
• The use of a non-shielded interface cable with the referenced device is prohibited. The length of the parallel interface
cable must be 3 meters (10 feet) or less. The length of the serial interface cable must be 15 meters (50 feet) or less.
• The length of the power cord must be 3 meters (10 feet) or less.
ICES:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conformme à la norme NMB-003 du Canada.
High Safety Required Use:
The Product is designed, developed and manufactured as contemplated foe general use, including without limitation,
general office use, personal use and household use, but is not designed, developed and manufactured as contemplated
for use accompanying fatal risks or dangers that, unless extremely high safety is secured, could lead directly to death,
personal injury, severe physical damage or other loss (hereinafter "High Safety Required Use"), including without
limitation, nuclear power core control, airplane control, air traffic control, mass transport operation control, life
support, weapon launching control. The Customer shall not use the Product without securing the sufficient safety
required for the High Safety Required Use. In addition, Fujitsu (or other affiliate's name) shall not be liable against
the Customer and/or any third party for any claims or damages arising in connection with the High Safety Required
Use by the Customer of the Product.
Energy Saving:
®
As an E S Partner, Fujitsu Limited has determined that this scanner meets E
NERGY TAR
energy efficiency. E
NERGY
The contents of this manual may be revised without prior notice.
All Rights Reserved, Copyright © 2001 FUJITSU LIMITED.
Printed in Japan.
No part of this manual may be reproduced in any form without permission.
®
S is a U. S. registered mark.
TAR
2
®
S guidelines for
NERGY TAR