Mounting The Clamps - Fujitsu fi-475PR User Manual

(2) Mounting the Clamps

Two types of clamps are used for securing the imprinter
cable. Mount the clamps as follows:
Clamps (black)
Use these clamps (black) to fix the imprinter cable.
1
Insert the clamps into the holes on the back of the
imprinter.
2
Fasten the imprinter cable with the clamps as shown
in the figure.
Clamp (white)
The clamp (white) holds the imprinter cable loosely. If the
imprinter cable hangs dowh loosely inthe way, use this
clamp. It is not necessary, keep the clamp not so as to lose
it.
3
Put the clamp (white) at the left part of the upper
shaft of the imprinter.
4
Hold the imprinter cable with the clamp as shown in
the figure below.
8