Setup; Control Panel - Formax FD 340 Operator's Manual

SETUP

1. Install upper and lower fold plates in position. Be sure
the plates are set fi rmly on the locating pins (Fig 1a
& 1b). Slide the fold plate in until it meets the fi rst
locating pin then push down to lock it in position
(Fig. 2).
2. Make sure the power switch is in the "OFF" position.
3. Plug the power cord into the power inlet and the wall
outlet.
Upper Fold Plate Pins
Fig. 1a

CONTROL PANEL

8
6
7
No. NAME
1 Power Indicator
2 Start Button
3 Stop Button
4 Test Button
5 Fault Indicator Lights
6 Batch Counting Button
7 "-" and "+" buttons
8 Reset Button
9 Counter Display
Locating Pins Locating Pins
9
1
5 5
FUNCTION
Lights up when power is on.
Press to run the machine. Will not operate if a red fault light is on.
Press to stop the machine.
Test folds two documents.
Stops the operation and indicates the problem area. Turn off the light by closing
cover, and/or placing paper on the in-feed tray. Press the "Reset" button to turn off
the "Fault detect" light.
Select the batch counting function.
Select the number of documents to be folded.
Resets the fault detect circuit and the counter.
CAUTION: when a fault happens and light is lit, only press the button one time. If
you press it a second time, you will reset the counter.
Shows the number of documents processed. When power is turned on it displays
"F-01".
Lower Fold Plate Pins
Fig. 1b
Fig. 2
2 3 4
2
Locating Pins Locating Pins Locating Pins Locating Pins