Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 4010 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 general-purpose
lithium-base grease. If the machine is operated under
normal conditions, lubricate all bearings and bushings
after every 50 hours of operation or immediately after
every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 58
Figure 59
(Figure
(Figure
(Figure 60)
(Figure 60)
(Figure 60).
58)
59)
Front Cutting Unit
•
Castor fork shaft bushings (2)
•
Spindle shaft bearings (3) (located under the
pulley) (Figure
•
Idler arm pivot bushings (2)
g009246
g004687
52
Figure 60
(Figure
62)
(Figure 62)
Figure 61
g011499
61)
g011557