Toro Groundsmaster 4010 Operator's Manual page 31

Refer to the following chart to determine the
combinations of spacers for the setting:
Figure 19
4. Push the castor spindle through the front castor
arm. Install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft. Install the tensioning cap to
secure the assembly.
5. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the cutting unit (Figure
Figure 20
1. Height-of-cut chain
6. Mount the height-of-cut chains to the desired
height-of-cut hole
and hairpin cotter.
Figure 21
20).
2. Clevis pin and hair pin
cotter
(Figure 21) with the clevis pin
Note:
(1-1/2 inch), or occasionally 51 mm (2 inch)
height-of-cut, move the skids and gage wheels
to the highest position.
decal100-5622nc
g011596
decal100-5624nc
31
When using 25 mm (1 inch), 38 mm