Toro Groundsmaster 4010 Operator's Manual page 33

Figure 25
8. Remove the hairpin cotters and clevis pins
securing the damper links to the cutting unit
brackets (Figure 26). Align the damper link
holes with the selected height-of-cut bracket
holes in the cutting unit frame
the clevis pins, and install the hairpin cotters.
Important:
The damper link length should
never be adjusted. The length between
the hole centers should be 13.7 cm (5-3/8
inches).
Figure 26
1. Damper link
Figure 27
Adjusting the Skids
The skids should be mounted in the lower position
when operating at heights of cut greater than 64
mm (2-1/2 inches) and in the higher position when
operating at heights of cut lower than 64 mm (2-1/2
inches).
Note:
the skid to the opposite sides of the mower, flipping
them over. This will allow you to use the skids longer
decal100-5623nc
before replacing them.
(Figure 27), insert
g011549
Adjusting the Cutting Unit Rollers
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than
64 mm (2-1/2 inches) and in the higher position when
operating in height of cuts lower than 64 mm (2-1/2
inches).
decal100-5694nc
33
When the skids become worn, you can switch
1. Loosen the screw at the front of each skid
(Figure 28).
Figure 28
2. Remove the flange-head bolts and nuts from
each skid (Figure
3. Move each skid to the desired position and
secure them with the flange-head bolts and nuts.
Note:
Only use the top or center sets of holes
to adjust the skids. The bottom holes are used
when switching sides at which time they become
the top holes on the other side of the mower.
4. Torque the screw at the front of each skid to 9 to
11 N⋅m (80 to 100 in-lbs).
1. Remove the bolt and nut securing the gage
wheel to the cutting unit brackets
28).
(Figure
g008867
29).