I Am Trying To Set The Leds On Site, How Can I Power The Lock; I Am Trying To Lock One Side Of The Lock But The Cabling Has Not Been Installed - How Can I Do This - Assa Abloy LOCKWOOD 3782 Troubleshooting Manual

I am trying to set the LEDs on site, how can I power the lock

• The lock can be powered via a micro-USB connector connected to a power bank, PC or mobile phone charger or it
can be powered by the main connector with a 9 or 12V battery connected to the red (+) and black (-) wires
• Refer to instructions for LED activation steps
I am trying to lock one side of the lock but the cabling has not been installed – how can I do this
• Set setting switches to required position (PtO will leave the lock locked once power has been removed)
• The lock can be powered via a micro-USB connector connected to a power bank, PC or mobile phone charger or it
can be powered by the main connector with a 9 or 12V battery connected to the red (+) and black (-) wires
o If powering by USB, the setting will only take effect after 30 seconds or if immediate response is required –
while powered, briefly press the LED and mode button and the lock will change to and remain in the failed
state. When the lock is powered through the main connector, normal operation will resume
o If powering through the main connector, connect and remove the green wire from the positive terminal of
the battery
- Ensure power is supplied to the lock for at least 5 seconds
9 Lockwood 3782EL Trouble Shooting Guide
1300 LOCK UP (1300 562 587) lockweb.com.au