Table of Contents
Advertisement
Alarm signal
The DWA alarm can be set off
by:
Motion sensor
Switch-on attempt with an
unauthorized ignition key.
Disconnecting the DWA from
the motorcycle battery (DWA
battery takes over the power
supply – alarm tone only, turn
indicators do not flash)
If the DWA battery is discharged
all functions remain operational;
the only difference is that the
alarm cannot be set off if the
system is disconnected from the
motorcycle battery.
The duration of the alarm is ap-
prox. 26 seconds. During the
alarm, an alarm tone sounds and
the turn indicators flash. The
type of alarm sound can be set
by an authorized BMW Motorrad
retailer.
OE
with Keyless Ride
A triggered alarm can be can-
celed at any time by pressing the
key remote button 1 without de-
activating the DWA.After the ig-
nition is turned off, both storage
compartments are locked after a
coastdown time.
If an alarm was activated while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
Light signals on DWA LED:
1 flash: motion sensor 1
2 flashes: motion sensor 2
3 flashes: ignition turned on
with unauthorized ignition key
4 flashes: alarm system dis-
connected from vehicle battery
5 flashes: motion sensor 3
DWA Deactivating
Switch on ignition.
with Keyless Ride
OE
Briefly press button 1.
Turn indicators light up once.
Confirmation tone sounds once
(if programmed).
4
83
z
Advertisement
Table of Contents
