Table of Contents
Advertisement
9
180
Remove the lens from the
housing by pulling it outward
on the side with the screw.
z
To prevent contaminants from
being deposited on the glass
surface, always use a clean, dry
cloth to hold the light source.
Remove bulb 1 from
light housing by turning it
counterclockwise.
Replace defective light source.
Bulbs for flashing turn
indicators, front
RY10W / 12 V / 10 W
Bulbs for flashing turn
indicators, rear
RY10W / 12 V / 10 W
Install light source 1 by turning
clockwise in light housing.
Insert inside end of lens into
light housing and close it.
Advertisement
Table of Contents
