BMW R 1250 R 2019 Rider's Manual page 44

Table of Contents

Advertisement

Contact an authorized service
3
facility, preferably an authorized
BMW Motorrad retailer.
42
Electronic oil-level check
The electronic oil-level
check evaluates the oil level
in the engine as OK or Low!
The following conditions must
be satisfied in order to use the
z
electronic oil-level check; multiple
measurements may be neces-
sary:
Rider is sitting on the motor-
cycle and the motorcycle has
been ridden at at least 10 km/h
beforehand.
Engine idling for at least 20
seconds.
Engine is at operating tempera-
ture.
Side (prop) stand is retracted
and motorcycle is not resting
on a center stand.
No brake is engaged and hill
start control (HSC) is not ac-
tive.
Motorcycle stands vertically on
a level surface.
The spring strut is set accord-
ing to the load status, or D-
ESA is in the Auto loading
mode.
If the measurement is incomplete
or the conditions specified above
are not fulfilled, an assessment
of the oil level is not possible.
Dashes (---) are indicated in
place of the note.
Electronic oil-level check:
check engine oil level.
Engine oil level.
Check engine oil
level.
Possible cause:
The electronic oil level sensor
has detected a low engine oil
level. If the motorcycle is not
standing vertically on a level sur-
face, the message can also ap-
pear even when the oil level is
correct. At next refueling stop:
Checking the engine oil level
(
161).
If the oil level is too low in the
inspection glass:
Topping up the engine oil
(
162).
If the oil level is correct:
Check whether the conditions
for the electronic oil level check
are fulfilled.
If the note appears multiple
times even though the oil level is
slightly below the MAX mark:
Contact an authorized work-
shop, preferably an authorized
BMW Motorrad retailer.

Advertisement

Table of Contents
loading

Table of Contents