Insulation; Hinge Pocket; Light Assembly - Wolf E Series Technical & Service Manual

E E - - S S e e r r i i e e s s W W a a l l l l O O v v e e n n
E E - - S S e e r r i i e e s s W W a a l l l l O O v v e e n n
TO AVOID ELECTRICAL SHOCK, POWER TO THE
UNIT MUST BE DISCONNECTED BEFORE
ATTEMPTING THE FOLLOWING REPAIRS.
Hinge Pocket Removal
The hinge pocket assembly is located behind the oven
side enclosure and insulation pack. Screws secure the
hinge pocket to the oven cavity face.
To remove the hinge pocket, the oven door will need to
be removed as well as the venting channels and oven
enclosure. Extract screws from the front bottom of the
oven cavity, then pull hinge pocket towards the back of
the unit and remove. (See Figure 4-35).

Light Assembly

The light assembly is accessed by removing the venting
channels and oven enclosure. The top rear panel will
need to be removed to allow access to the quick dis-
connect for the oven lights. The insulation pack does
not have to be fully removed to remove light assembly.
To remove the light assembly:
1. Disconnect wire harness for light assembly at the
quick disconnect located near the transformers on
the electrical component mounting plate under the
top rear panel.
2. Push down on retaining clips at top of light assem-
bly and push through into oven cavity.
(See Figure 4-36)
Component Access & Removal

Hinge Pocket

Insulation

Figure 4-35. Enclosure Removal.
Insulation
Figure 4-36. Light Assembly Removal.
4-15
Screws
Press
Here