Engine Oil Drain Pump - Mercury 6.2 Inboard MPI DTS Operation & Maintenance Manual

Section 4 - Maintenance
2. Add the specified engine oil to bring the level up to, but not over, the FULL or OK range mark on the dipstick. Check the oil
level.
3. Replace the fill cap.
All Models
Engine oil (with filter)

Engine Oil Drain Pump

1. Loosen the oil filter to vent the system.
2. Remove the dipstick.
3. Install the oil pump onto the dipstick tube.
a
b
4. Insert the hose end of the crankcase oil pump onto an appropriate container and use the handle to pump until the
crankcase is empty.
5. Remove the pump.
6. Install the dipstick.
Page 36
In-line dive model shown
Capacity
4.7 L (5 US qt) Mercury/Quicksilver 25W‑40 Synthetic Blend Engine Oil, NMMA FC‑W
a -
b -
c -
c
mc70571-1
58404
Fluid Type
Oil pump
Dipstick tube
Oil drain hose
90-8M0119292 MAY 2016
eng