Flame Arrestor - Mercury 6.2 Inboard MPI DTS Operation & Maintenance Manual

Section 4 - Maintenance

Flame Arrestor

Fuel is flammable and explosive. Ensure that the key switch is off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
1. There are two engine covers you must remove to access the flame arrestor:
a. Pull the outside engine cover up to remove it from the four rubber mount grommets.
b. Carefully guide the cover past the O
c. Lift up on the front of the second cover to disengage the cover from the front grommets. Pull the cover towards the
front of the vessel to remove it from the two rear grommets.
b
a
2. Loosen the clamp securing the flame arrestor and remove the flame arrestor.
a
Page 40
sensors.
2
b
b
a
58810
Flame arrestor
a -
b -
b
61328
WARNING
!
58808
a - Front grommets
b - Rear grommets
Clamp securing the flame arrestor
Flame arrestor
90-8M0119292 MAY 2016
eng