Snmp - Digital Watchdog MEGApix DWC-MVT4Wi28 User Manual

After the domain name is successfully applied for, the domain name will be listed as
below.
3. Enter the username, password, domain you apply for in the DDNS configuration
interface.
4. Click the "Save" button to save the settings.

6.6.5 SNMP

To get camera status, parameters and alarm information and remotely manage the
camera, the SNMP function can be used. Before using SNMP, please install an SNMP
management tool and set the parameters of the SNMP, such as SNMP port, trap
address.
1. Go to Config→Network→SNMP.
2. Check the corresponding version checkbox (Enable SNMPv1, Enable SNMPv2,
Enable SNMPv3) according to the version of the SNMP software that will be used.
3. Set the values for "Read SNMP Community", "Write SNMP Community", "Trap
Address", "Trap Port" and so on. Please make sure the settings are the same as that
of the SNMP software.
Note: Please use the different version in accordance with the security level you
required. The higher the version is, the higher the level of the security is.
39