Table of Contents
Advertisement
SAVING SETTINGS AND EXITING THE
SETUP MENU
Press the ENTER key and the Z-2000-T
will save the setup menu settings and exit
the program. The LCD will display the
space temperature along with other
normal operating functions. To review the
thermostat settings, simply press and hold
the SETUP key until the setup menu is
displayed and then toggle through the
settings. Press the ENTER key to exit the
setup menu. Remove the thermostat from
the subbase and set Switch 1 in the ON
position to lock the thermostat which will
prevent setup changes from being made.
When the thermostat is locked, a padlock
icon will be displayed on the LCD.
(Figure 12)
FIGURE 12
HELPFUL HINT
If it is necessary to exit the setup menu
before all setup functions are completed,
simply press the ENTER key and all
settings will be saved.
To re-enter the setup menu, press and
hold the SETUP key until the word
DAMPER appears and then continue
pressing the SETUP key to toggle through
the functions to where you left off.
CHECKING THERMOSTAT
STATUS POINTS
After the thermostat is locked and
operational, its status functions can be
checked by pressing the STATUS key
twice and toggling through the following
status points:
UNIT - Displays the HVAC unit number
assigned to thermostat.
ZONE - Displays the thermostat zone
number.
DUCT - Displays the duct temperature.
DAMPER - Displays the damper position
in one degree increments.
(0% = fully closed and 100% = fully open)
THERMOSTAT OPERATION
The Z-2000-T is designed to provide
accurate but simple temperature control
for the user. When the thermostat is not
calling, only the space temperature is
displayed on the LCD along with the
padlock icon that confirms the thermostat
setup functions can not be changed. The
user can use the UP and DOWN keys to
change the thermostat setpoint within the
setpoint limits and review the status
points by pressing the STATUS key.
(Figure 13)
9
FIGURE 13
www.jacksonsystems.com
1.888.652.9663
Advertisement
Table of Contents
