Table of Contents
Advertisement
INTRODUCTION
The Comfort System™ Z-2000-T
thermostat is designed to work with the
Z-2000™ modulating zone control
system and the Zone One™ stand-
alone zone damper and diffuser. Please
take time to read and understand this
manual so that installation and testing is
undertaken in an efficient and effective
manner.
Although great care has been taken in
the preparation of this manual, Jackson
Systems takes no responsibility for
errors or omissions contained herein. It
is the responsibility of the installer to
ensure that this thermostat and the
equipment connected to it operate in a
safe and efficient manner.
Due to ongoing product improvement,
Jackson Systems reserves the right to
change the specifications of the
Z-2000-T without notice.
All right reserved.
© Jackson Systems, LLC 2010
Intellectual rights apply.
DISASSEMBLY
Insert a small coin (dime) in the release
slot located on the bottom of the
thermostat. Gently twist the coin to
release the thermostat from the
subbase. Avoid twisting the case, as this
may stress the LCD and cause it to
crack or bend the terminal pin
connectors.
TERMINAL DESIGNATIONS
The Z-2000-T has dedicated screw
terminals located on the subbase to
facilitate ease of wiring to the actuator
board mounted on all Z-2000™ and
Zone One™ dampers. When wiring the
Z-2000-T to the actuator board, use
standard 18-8 thermostat (verify with
local codes if plenum rated wire is
required).
Z-2000-T SUBBASE
C R PO PC
C
R
PO
PC
DS
DS
Y
W
A
B
2
DS DS Y W A B
24 Volt Common
24 Volt Hot
Power Open
Power Close
Duct Sensor
Duct Sensor
Cooling Relay
Heating Relay
Modbus
Modbus
www.jacksonsystems.com
1.888.652.9663
Advertisement
Table of Contents
