Installing The Scanner - IBM Anyplace Kiosk 4836 Planning, Installation And Service Manual

Installing the scanner

1. As shown in Figure 5, place the IBM 4836 face down on a sturdy surface.
Figure 5. Installing the scanner
2. Lift the cable covers as described in "Opening the cable covers" on page 9.
3. Unfasten the screw ( A ) holding the scanner bay cover ( B ). Discard the
4. Connect the scanner cable ( C ) to the connector ( E ).
5. Align the tabs ( D ) on the scanner with the adjacent slots on the cover and
6. Secure in place by inserting the screw ( A ).
Note: For best scanning results, hold the object to be scanned 2 to 4 inches away
Installing the MSR
Note: Install the MSR after you mount the IBM 4836. See "Mounting instructions"
1. See Figure 6 on page 12. Remove the hard drive door by unfastening the two
2. With the IBM 4836 mounted onto the desired stand, locate the mounting
All manuals and user guides at all-guides.com
A
B
cover, but retain the screw for step 6.
slide into position.
from the scanner.
on page 14.
screws located on the door and discard.
features for the MSR on the right side of the machine.
Chapter 2. Installing the IBM Anyplace Kiosk
C
D
E
11