Table of Contents
Advertisement
Figure 17. Removing a memory module
4. Hold the memory module by the edges and pull it out of the system.
5. If the removed part is used again, place the part on an electrostatic discharge (ESD) mat.
Replacing a memory module in the 9040-MR9 system
To replace a memory module in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Use the slot information that you recorded to determine the slot location to place the memory module.
3. Grasp the new memory module along its edges and align it with the slot.
Attention: Memory modules are keyed to prevent a memory module from being installed
incorrectly. Note the location of the key tab within the memory module connector before you
attempt to install the memory module.
4. Ensure that the locking tabs of the memory module connector are open. Slowly press the memory
module straight down, firmly into the slot, until the locking tabs lock into place. See Figure 18 on page
25.
24 Power Systems: Power Systems: Memory
Advertisement
Table of Contents
