Locating And Resetting The Cmos Jumper; Location Of The Cmos Jumper - IBM Anyplace Kiosk 4836 Planning, Installation And Service Manual

Locating and resetting the CMOS jumper

Follow these steps to locate and reset the CMOS jumper:
1. Remove the cover as described in "Removing the back cover" on page 28.
Figure 19. Location of the CMOS jumper
2. Locate the blue CMOS jumper on the main planar assembly. See Figure 19.
3. Remove the jumper from the board and wait several seconds.
4. Reinstall jumper to reset defaults.
32
Anyplace Kiosk 4836
All manuals and user guides at all-guides.com
The jumper is located near the hard drive and beside the radio card.