Display Messages - Thermoplan AGUILA AG220 Service And Technical Manual

SECTION VI
Service and Technical Manual
Display message
Insert capsule drawer!
Empty capsule drawer!
Energy saving mode
Press any key
Change water filter
Service required
Call technician
Voltage too high
Voltage too low
6.76
Possible reason
x Capsule drawer not inserted or
not inserted correctly
x Reed contact defective
x Magnet on drawer missing
Maximal amount of capsules in used
capsules drawer reached.
Machine is in energy saving mode
x Standby mode 2 active
x Main switch in OFF position
Filter cartridge is at it's limit
Machine reached max. brew cycles;
12 months since the installation / the
last PM have passed.
The user sees this message if there
is an NTC, milk pump or flowmeter
error.
Repeated technical error.
Operation is stopped because
voltage is out of the set tolerance
range.
If the voltage gets too high during a
product dispensing, the product will
be finished, then the operation stops.
Operation is stopped because
voltage is out of the set tolerance
range.
If the voltage gets too low during a
product dispensing, the product will
be finished, then the operation stops.
REV-5
Black

Display messages

Solution
White
x Insert capsule drawer correctly
x Check reed in input test
x Replace magnet
Empty used capsule drawer and
reinsert
Press any key to restart machine and
wait until „Ready" is shown
x Press energy save button
x Set main switch to ON
Replace filter cartridge and reset wa-
ter counter (service menu „Statistics"
► „Water counter reset")
Perform the PM and reset the service
counter.
x Turn machine off and back on.
x Check error history and eliminate
any recent errors.
x Perform an irregular PM, do not
reset the service counter!
x Wait until voltage stabilises.
x Let an expert check and adjust
the voltage of the power socket.
x Wait until voltage stabilises.
x Let an expert check and adjust
the voltage of the power socket.
© 2015 by Thermoplan AG, Subject to change