Webasto DVS300 Installation Manual page 9

Intelligent Fast-Charging System
WARNING
IMPROPER INSTALLATION CAN CAUSE FIRE
•
•
•
•
•
•
•
•
•
•
•
•
•
CAUTION
ELECTROSTATIC DISCHARGE PRECAUTIONS
Electronic circuits are sensitive to damage from electrostatic discharge (ESD).
Persons servicing this equipment should be trained in proper techniques for avoiding
ESD damage to electronic circuits.
•
31504-76-0101
GSE Installation Guide for the DVS300/330/400 and MVS330/400
Do not install or place the unit on, over, or near combustible surfaces.
Do not install the unit near flammable items.
Do not block the air intake to, or exhaust from, the unit.
Do not block airflow to the unit.
Replace blown fuses only with the same type and rating of fuse.
Do not overload the building wiring: be sure that the utility power service is
properly sized, rated, and protected to handle this unit. Use the unit only with the
circuits provided, with the minimum wire size specified in the installation section.
Protective bollards should be installed where the
damage from vehicle activity.
Do not install the power station if there is physical damage to the power station,
coupler, or cable.
Do not subject the cable or coupler to damage or stress. Do not step on the
coupler cable.
Do not hang the power station
Do not disassemble the DVS or power station.
Use the metal conduit only above ground.
Follow the National Electrical Code (NEC) and local codes, both of which take
precedence. If any instructions in this guide conflict with NEC or local codes,
then contact WCSI for further information.
Wear an appropriate ESD wrist strap connected to the equipment chassis,
as a minimum, when handling circuit boards.
Page 9 of 40
GSE
from the coupler cable.
Webasto Charging Systems, Inc.
location is subject to