Summary of Contents for ZKTeco SpeedFace-V3L (Lite)
Page 1
Installation Guide SpeedFace-V3L (Lite) Version: 1.0 Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
How to install the device? Installation Environment Please refer to the following recommendations for installation. INSTALL INDOORS AVOID INSTALLATION AVOID DIRECT AVOID USE OF ANY ONLY NEAR SUNLIGHT HEAT SOURCE GLASS WINDOWS AND EXPOSURE NEAR THE DEVICE Installation on the wall Attach the mounting template sticker to the wall, and drill holes ① according to the mounting paper.
How to connect the device? Refer to the following wiring to connect the device. Terminal Block Network Interface Exit Button Power In +12V Sensor Lock BELL- Bell BELL+ Exit Button, Door Sensor & Bell Connection Exit Button BELL- BELL+ Door Sensor Bell...
Power Connection AC Adapter DC12V Recommended AC adapter: 12V ± 10%, at least 1500mA. Use an AC adapter with a higher current rating to share power with the other devices. Ethernet Connection Connect the device and the computer software over an Ethernet cable. As shown in the example below: ZKBioAccess Default IP address: 192.168.1.201...
Lock Relay Connection The system supports Normally Opened Lock and Normally Closed Lock. The NO LOCK (normally opened at power on) is connected with 'NO' and 'COM' terminals, and the NC LOCK (normally closed at power on) is connected with 'NC' and 'COM' terminals. Take NC Lock as an example below: Device not sharing power with the lock DC12V...